KILZ® Siding, Fence And Barn Paint

Masterchem Industries

KILZ® Siding, Fence and Barn Paint for all exterior vertical wood surfaces. This product provides excellent adhesion to a variety of other surfaces such as masonry and stucco. The unique water/oil base formula resists cracking, peeling and blistering.

Preparation, Application & Clean-Up

SURFACE PREPARATION^†

Remove any mildew stains with a bleach and water solution or similar commercially available mildew remover then rinse.
Sand all glossy surfaces.
To determine the condition of the surface, place cloth duct tape in several places on the bare wood. Press the tape down firmly then remove quickly. If wood fibers or debris are pulled onto the tape, additional preparation is required as follows:
If debris is found using the above test, remove any loose or peeling paint† and wash off dirt or grease with a non-soapy detergent such as TSP substitute. Remove mill glaze, loose wood fibers, dirt and other debris. Rinse with water and allow to dry completely.
If surface is in good condition, apply directly over clean, dry surface.

APPLICATION

Do not use if temperature is below 50°F (10°C) or if rain is expected within 24 hours.
All surfaces must be completely dry.
Intermix containers of the same color to ensure color uniformity.
Many woods contain tannin which may cause discoloration. Prime these woods with one coat of KILZ PREMIUM to reduce these stains as needed.
Coverage varies by porosity. Coverage will be approximately 200 square feet per gallon on porous surfaces; up to 500 square feet per gallon on smooth, nonporous surfaces.
Keep a wet edge and always back-brush or back-roll during all application methods.
Airless Spray - .015 to .017 tip.
Brush - Use a high quality Nylon/Polyester brush.
Rolling - Use a high quality 3/8-1/2" nap roller cover on smooth surfaces or 1/2-3/4" nap roller cover on semi-rough or porous surfaces.

Dry Time

Dries to the touch in 2-3 hours.
Allow 6 to 8 hours of drying prior to recoating.

CLEAN UP & DISPOSAL

Use soap and water to clean hands, tools, and spills.
Do not dispose of this product down a drain. Please consider donating any unused product. For recycling or disposal information contact your local household refuse collection service.

CAUTIONS/LIMITATIONS

Protect from freezing.
Not for use on horizontal surfaces subject to foot traffic.
For best results, apply at temperatures between 50 - 90°F. Temperatures above 90°F may affect the application such as drying too fast. Avoid painting in direct sun. NOTE: If the surface is hot to the touch it should be considered too hot to apply this coating.
Avoid heavy traffic for 24 hours.
Allow two weeks before washing or cleaning for full cure.
Shelf life under normal conditions is two years unopened.